DRV8833 Dual Motor Driver Carrier

LKR 3,600.00
Out of stock
SKU
2130

This tiny breakout board for TI’s DRV8833 dual motor driver can deliver 1.2 A per channel continuously (2 A peak) to a pair of DC motors. With an operating voltage range from 2.7 V to 10.8 V and built-in protection against reverse-voltage, under-voltage, over-current, a

This board is very similar to our DRV8835 dual motor driver carrier in operating voltage range and continuous current rating, but the DRV8835 has a lower minimum operating voltage, offers an extra control interface mode, and is 0.1″ smaller in each dimension; we also carry a DRV8835 dual motor driver shield that is easy to use with an Arduino. The DRV8833 has a higher peak current rating (2 A per channel vs 1.5 A), optional built-in current-limiting, and no need for externally supplied logic voltage.

For a smaller, lower-cost, single-channel alternative to this driver, please consider our DRV8838 carrier, which offers a similar operating voltage range and current capabilities

Features

  • Dual-H-bridge motor driver: can drive two DC motors or one bipolar stepper motor
  • Operating voltage: 2.7‌‌ V to 10.8 V
  • Output current: 1.2 A continuous (2 A peak) per motor
  • Motor outputs can be paralleled to deliver 2.4 A continuous (4 A peak) to a single motor
  • Inputs are 3V- and 5V-compatible
  • Under-voltage lockout and protection against over-current and over-temperature
  • Reverse-voltage protection circuit
  • Current limiting can be enabled by adding sense resistors (not included)

Dimensions

Size: 0.5″ × 0.8″1
Weight: 1.0 g1

General specifications

Motor driver: DRV8833
Motor channels: 2
Minimum operating voltage: 2.7 V
Maximum operating voltage: 10.8 V
Continuous output current per channel: 1.2 A2
Peak output current per channel: 2 A
Continuous paralleled output current: 2.4 A2
Reverse voltage protection?: Y
More Information
N/A
Write Your Own Review
You're reviewing:DRV8833 Dual Motor Driver Carrier
Your Rating