Pololu 9V Step-Up/Step-Down Voltage Regulator S10V3F9

LKR 1,500.00
In stock
SKU
2095

This switching regulator uses the SEPIC topology to produce 9 V from input voltages between 2.5 V and 18 V. The wide input range coupled with its ability to convert both higher and lower input voltages makes it useful for applications where the power supply voltage can vary greatly, as with batteries that start above but discharge below 9 V. The compact (0.4″ × 0.575″) module can supply over 300 mA in typical applications.

The Pololu step-up/step-down voltage regulator S10V3F9 is a switching regulator (also called a switched-mode power supply (SMPS) or DC-to-DC converter) with a single-ended primary-inductor converter (SEPIC) topology. It takes an input voltage from 2.5 V to 18 V and increases or decreases the voltage to a fixed 9 V output with a typical efficiency of 70% to 80%.

This flexibility in input voltage is especially well-suited for battery-powered applications in which the battery voltage begins above 9 V and drops below as the battery discharges. Since it lacks the typical restriction that the battery voltage stay above the required voltage throughout its life, new battery packs and form factors can be considered. For instance, a 7-cell battery holder, which might have an 11 V output with fresh alkalines but an 8.4 V nominal voltage with NiMH cells and a 7 V output with partially discharged cells, can now be used to produce a steady 9 V output.

In typical applications, this regulator can deliver over 300 mA continuous; please see the graphs at the bottom of this page for a more detailed characterization. The regulator’s thermal shutdown prevents damage from overheating, but it does not have short-circuit or reverse-voltage protection.

Dimensions

Size: 0.4″ × 0.575″ × 0.1″1
Weight: 0.6 g1

General specifications

Minimum operating voltage: 2.5 V
Maximum operating voltage: 18 V
Maximum output current: 300 mA2
Output voltage: 9 V
Reverse voltage protection?: N
Maximum quiescent current: 2 mA3

Identifying markings

PCB dev codes: reg11a
Other PCB markings: 0J7068

Notes:

1
Without included optional headers.
2
Typical maximum that can be delivered continuously without overheating. Actual maximum output current depends on input voltage.
3
While enabled (SHDN floating) with no load. Actual quiescent current depends on input voltage.

Dimensions

Size: 0.4″ × 0.575″ × 0.1″1
Weight: 0.6 g1

General specifications

Minimum operating voltage: 2.5 V
Maximum operating voltage: 18 V
Maximum output current: 300 mA2
Output voltage: 9 V
Reverse voltage protection?: N
Maximum quiescent current: 2 mA3

Identifying markings

PCB dev codes: reg11a
Other PCB markings: 0J7068

Notes:

1
Without included optional headers.
2
Typical maximum that can be delivered continuously without overheating. Actual maximum output current depends on input voltage.
3
While enabled (SHDN floating) with no load. Actual quiescent current depends on input voltage.
More Information
N/A
Write Your Own Review
You're reviewing:Pololu 9V Step-Up/Step-Down Voltage Regulator S10V3F9
Your Rating