150 RPM Micro Metal Gearmotor MP 6V with Extended Motor Shaft

LKR 3,550.00
Out of stock
SKU
2382

This gearmotor is a miniature medium-power, 6 V brushed DC motor with a 150.58:1 metal gearbox. It has a cross section of 10 × 12 mm, and the D-shaped gearbox output shaft is 9 mm long and 3 mm in diameter. This version also has a 4.5 × 1 mm extended motor shaft.

Key specs at 6 V: 150 RPM and 40 mA with no load, 28 oz-in (2.0 kg-cm) and 0.7 A at stall.

Overview

These tiny brushed DC gearmotors are available in a wide range of gear ratios—from 5:1 up to 1000:1—and with five different motors: high-power 6 V and 12 V motors with long-life carbon brushes (HPCB), and high-power (HP), medium power (MP), and low power (LP) 6 V motors with shorter-life precious metal brushes. The 6 V and 12 V HPCB motors offer the same performance at their respective nominal voltages, just with the 12 V motor drawing half the current of the 6 V motor. The 6 V HPCB and 6 V HP motors are identical except for their brushes, which only affect the lifetime of the motor.

The HPCB versions (shown on the left in the picture below) can be differentiated from versions with precious metal brushes (shown on the right) by their copper-colored terminals. Note that the HPCB terminals are 0.5 mm wider than those on the other micro metal gearmotor versions (2 mm vs. 1.5 mm), and they are about 1 mm closer together (6 mm vs. 7 mm).

Dimensions

Size: 10 × 12 × 26 mm
Weight: 9.5 g
Shaft diameter: 3 mm

General specifications

Gear ratio: 150.58:1
Free-run speed @ 6V: 150 rpm
Free-run current @ 6V: 40 mA
Stall current @ 6V: 700 mA
Stall torque @ 6V: 28 oz·in
Extended motor shaft?: Y
Motor type: 0.7A stall @ 6V (MP 6V)
More Information
N/A
Write Your Own Review
You're reviewing:150 RPM Micro Metal Gearmotor MP 6V with Extended Motor Shaft
Your Rating